In the high temperature of the work of the shredding machine electromechanical how to maintain the talent through the hot summer. Things can not be exposed to the sun, let alone our work shredder! Shredder in the waste processing is essential equipment, the motor is the base of the equipment. Assuming that the motor is bad, then the equipment can not run normally, so to protect the motor parts.

How to clean the shredder motor shortcomings, the following manufacturers teach you a few small good methods:

1. The motor department work to check the motor bearing is not excessive wear or poor device, constitute stator, rotor phase friction, so that the iron core surface damage, which in turn constitutes a short circuit between the silicon steel sheet, motor iron loss increase, so that the motor temperature rise is too high. At this time, the use of fine files and other things to remove burrs, eliminate the silicon steel short, clean up after coated with insulating varnish, and heating and drying.
2. Work at high temperatures to keep checking the motor core and the seat of the contact between the loose, you can tighten the original positioning screws. If the positioning screws fail, can be re-drilled and tapped positioning holes in the seat, tighten the positioning screws. Bearing shortcomings repair rotating shaft through the bearing support tumbling, is the heaviest load some, but also a brief wear parts.

Following the development of scientific skills, the knowledge of metal crushing has also made great progress. Granular metal selection of a variety of different crushing methods, you can get a few microns of metal, in order to adapt to a variety of skill requirements.

In industry, today's widely used metal crushing methods are still mechanical force crushing, kneading, splitting, breaking, grinding and impact crushing. Non-mechanical force crushing has not yet been used in large industrial production.